V3I11P13

Strength Development Index and Regression Analysis of Concrete Latex-Modified Asphalt Concrete under Prolonged Water Submergence

Ndamele Foby1, Igwe Ewuso A. 1, Oba, Achemie Lewis1*

Abstract

Moisture-induced damage is a leading cause of premature failure of asphalt pavements in the flood-prone Niger Delta, yet locally available polymer additives remain largely unexplored. This study evaluates concrete latex, a low-cost polymer emulsion sold in Port Harcourt building-materials markets, as a modifier for dense-graded asphalt concrete. Gravel, sand and asphalt cement (penetration 66.7) were blended and designed at an optimum binder content of 5%. Concrete latex was added at 0, 2, 4, 6, 8 and 10%, and specimens were submerged in water for 0, 1, 2, 3, 4 and 7 days before unconfined compressive strength (UCS) testing. The strength development index (SDI), retained strength, two-way analysis of variance and regression were used to interpret the results. Unconditioned UCS rose from 6.83 MPa for the control to a peak of 7.68 MPa at 6% latex (SDI = 0.124). After seven days the control retained 79.4% of its initial strength, compared with 89.5% and 89.9% for the 2% and 4% mixes and 83.3% for the 6% mix, giving SDI values of 0.15 to 0.19 for the 2–6% mixes. Latex content and immersion time were both highly significant (p < 0.001). Quadratic regression placed the optimum dosage near 7.6% for dry specimens but near 5.5% after seven days, and the 8% and 10% mixes lost strength sharply between days four and seven. A dosage of 4–6% is therefore proposed. Because each condition is represented by a single reported value, replicated testing and field trials are recommended.

Keywords:

Concrete latex; asphalt concrete; Moisture damage; Unconfined compressive strength; Strength development index; Regression analysis.